Pump builder

This issue concerns pump models created in version 5.4 (Bosch-Rexroth, Eaton, Denison, etc.) and then reopened with Automation Studio™ version 5.5. You must be aware that if the data is modified in the pump configuration interface, and validated by clicking on the ‘Apply’ button, the pump version will change and it will be upgraded to version 5.5.

However, if there is a motor connected to the pump, you have to replace the motor with a new one in order for the pump to function properly.

Example:

- A pump model for Bosch-Rexroth created with a version 5.4 and then reopened with the version 5.5.

- After modifying some of the data in the builder, the pump upgrades to a version 5.5 model.

- Since a motor is connected to the pump, you must replace it in order for the simulation to function properly.