Dynamic and Realistic Simulation
in Full Color

Automation Studio™ simulation capabilities meet the
requirements of all supported technologies. During
simulation, components become animated and lines are color-coded according to their states. You can also monitor
variables such as pressure, flow, displacement, current, and voltage at any point in a circuit.

Flexible Simulation Parameters

The default simulation parameters supplied with the components eliminate the need to perform initial setup. Simply insert your components and start the simulation. At any time during simulation, you can adjust component parameters and manually control just about any device.

Partial List of Simulated Phenomena:

• Laminar and turbulent flow
• Dynamic and hydrostatic pressure
• Pressure drop based on flow type
• Fluid viscosity based on temperature and pressure
• Fluid compressibility based on Bulk Modulus and pressure level
• Cavitation based on vapor pressure of the oil
• Heat exchange based on isothermal, polytrophic and adiabatic transformation
• Multi-fluid system
• Motor and pump volumetric and total efficiency
• Very high pressure system (›5000 Bar)
• Voltage, current, power, frequency, phase
• Resistive, inductive and capacitive effect
• Atmospheric pressure
• Steady-state

System Analysis Tools

Various monitoring tools are available to analyze, verify, and record your operational system behavior:

• Simulation modes
• Multi-document simulation
• Layer simulation
• Dynamic measuring instruments
• Hydraulic tester
  
• Thermometer
  
• Pressure and flow gauge
  
• Numerical snapshot

• Open path detection
  
• Component repair
  
• Plotter
  
• Recorder
  
• Multimeter
  
• Faulty component highlight
  
• Oscilloscope
  
• Log reports